TD100 2020-03-26T17:56:04+08:00

Stainless steel Contact Button Patrol System TD100

TD100 Touch Guard Patrol Reader is a very popular product on the market. Small-sized, durability, and low power consumption are its biggest advantages. With unique design and special adhesive, TD100 Touch Guard Patrol Reader is total waterproof. The unique design that there is not any screw on the surface makes it super durable. One 3.7V lithium battery can read buttons 270,000 times continuously. If you need a dependable, tamper-proof data collection system, TD100 system is the obvious choice.

System components       
1. Contact  Guard Patrol reader TD100
2. Downloader Base Station

Features

Brilliant exterior design, small-sized, light and easy carrying
With special waterproof pad and adhesive in the reader, completely water resistant
No screws on surface, sabotage resistant
Shock proof and easy maintenance
LED flash prompt at the touch of the button
Real time internal clock
3000 records storage capacity
Low power consumption
Long battery life, 270,000 continuous reads

Physical Durable stainless steel case with rubber outer shell
Dimensions 155XΦ27.5mm
Operating Temperature -45° to +85°C
Humidity 5% to 95% non-condensing
Storage Capacity 3000 pieces records
Battery 3.7 V rechargeable lithium battery, 800mAh
Signal Card Detection Auto induction card-reading
Card Reading Distance 3cm-5cm
Communication With USB2.0 downloader base station
Weight                230g
Waterproof & Dustproof IP67
Anti-explosion ExiaⅡBT4

TD100 downloader station provide the communications link between the TD100 reader and the computer.
With available communication speed of up to 19200 baud read, downloading a TD100 reader to your computer takes only a few seconds.

Technical Information
D100t Downloader Base Station
Dimention  130X180X40mm
Weight                   350g
Power Supplies  120v, 60Hz, 220v, 50Hz
Indicator Lights Power, Transmit, and Receive
Connection Ports Computer and Power
Guard ID Touch iBttons
Checkpoint Touch iBttons

Touch Memory Buttons are electronic memory chips contained in small water-resistant,water-resistant stainless steel canister. All Touch Memory Buttons (TM card, iButton) contain a unique ID number that is unalterable and identifies each button. The Touch Memory Button’s stainless steel container protects the memory chip and provides an electrical path for communication with the TD100 reader. The top of button is connected to the enclosed memory chip circuit, and the bottom and sides provide a signal ground. When you touch a button with the TD100 reader, an electrical connection is established data is transferred instaneously. You can attach buttons to virtually anything by using permanent adhesive pads, mounting brackets, or key ring tabs.

Hardware quick start guide

  1. The patrolling guard takes the reader and touches his own Guard ID to identify himself with the system.
  2. The guard will then proceed to the designated stations and touch the installed station iButtons accordingly. The data and time will be recorded in the reader for every station touching.
  3. After patrolling, the guard will hand it over to the supervisor who will upload patrolling data to software via downloader station and have a data analysis and management.